Is there supposed to be a nut on my end links?
#1
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
I was looking into doing a swaybar quick disconect and my end links don't have any nuts on the top. Only on the bottom.
![](http://i1114.photobucket.com/albums/k535/thogert/swaybar004.jpg)
It's like that on both sides.
![](http://i1114.photobucket.com/albums/k535/thogert/swaybar002.jpg)
Shouldn't they just fall off if they arn't held on by anything?
![](http://i1114.photobucket.com/albums/k535/thogert/swaybar004.jpg)
It's like that on both sides.
![](http://i1114.photobucket.com/albums/k535/thogert/swaybar002.jpg)
Shouldn't they just fall off if they arn't held on by anything?
#2
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
hmm from the looks of it there suppose to be a nut on them Ill take a look around for ya
#3
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
I know that every thread I looked at they had lock washers on them and the aftermarket ones I'm looking at have them. It's just strange that they are connected still. I tried pulling on them but they didn't move.
#4
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
![](http://www.genmotorinfo.com/images/426517570/131700073.png)
from the looks of this there suppose to be a nut there but i put 4wd and it gave me 2wd
#6
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
So it should just come off then. I'll be back, I'm gonna go check.
#7
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
I doubt its going to come right out since its on pressure
#8
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
Well it looks like the top washer is octagonal and there is no space between the washer and the bolt. It almost looks like the washer is the top bolt.
#9
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
yea it looks so weird like that tho
#10
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
I just want to know how to get it off so I can replace it. I suppose a hacksaw and a hammer would work.
![Icon Razz](https://blazerforum.com/forum/images/smilies/icon_razz.gif)