Worked on replacing the silver part on this two piece body moulding by using silver lower door panel guard (outer) and wrapped it around the silver part of the trim and reattached it with 3-M double faced tape. On the rest of the body trim, I had to cut the silver part off (you have to pull the entire trim piece off,remove old adhesive tape from body and the trim) and wrapped it the same way there is about an 1/8 of an inch that is on the back of the trim. I wrapped it that way to keep out water, dirt and salt. It is a little tricky, but its well worth the results. Only time will tell how it holds up !