Blazer Forum - Chevy Blazer Forums
0 2025/06/01 09:42:16
0 2025/06/01 09:40:51
0 2025/06/01 09:33:42
0 2025/04/18 09:48:40
0 2025/04/18 09:48:03
0 2025/04/04 09:10:03
0 2025/04/04 09:09:12
0 2025/04/04 08:30:12
0 2025/03/31 08:43:23
0 2025/03/31 08:42:59
0 2024/11/13 08:55:17
0 2024/11/13 08:54:03
Page from GM 1977 Unit Repair manual.
Page from GM 1977 Unit Repair manual.
0 2020/08/25 18:01:45
Page from GM 1977 unit repair manual.
Page from GM 1977 unit repair manual.
0 2020/08/25 18:01:35
Pulley puller tool from Tacoma Screw Co.
Pulley puller tool from Tacoma Screw Co.
0 2020/08/25 18:01:24
Finished, painted pump in operation.
Finished, painted pump in operation.
0 2020/08/25 18:01:16
Close up of grease zerk on front U joint and to the left , the grease port for the cardan ball, a dimpled place with a hole. The ball aligns the two U joints and must be replaced when replacing the U joints. A special tool is required to grease these ports.
Close up of grease zerk on front U joint and to the left , the grease port for the cardan ball, a dimpled place with a hole. The ball aligns the two U joints and must be replaced when replacing the U joints. A special tool is required to grease these ports.
0 2020/08/18 12:00:57
78 K5 . Looking back from inside of front right wheel to double cardan joint fastened to transfer case. Two U joints connected with a ball joint in between.
78 K5 . Looking back from inside of front right wheel to double cardan joint fastened to transfer case. Two U joints connected with a ball joint in between.
0 2020/08/18 12:00:42
Ball joint threaded into coupler nut welded to a spacer to the Z arm. The rod above comrs thru the floor from the clutch pedal.
Ball joint threaded into coupler nut welded to a spacer to the Z arm. The rod above comrs thru the floor from the clutch pedal.
0 2020/08/18 11:49:21
Ball joint linkage. Grease zerk on top side of ball joint head. Large bearing ball with grease at the left end of thenuts welded together. The ball joint is mounted to a small piece if steel welded to the stock Z arm.
Ball joint linkage. Grease zerk on top side of ball joint head. Large bearing ball with grease at the left end of thenuts welded together. The ball joint is mounted to a small piece if steel welded to the stock Z arm.
0 2020/08/18 11:49:06
0 2020/08/15 10:15:54
0 2020/08/15 10:08:35
0 2020/08/15 09:56:22