Announcements / New Member Area Today 11:26 AM
Welcome. Nice Blazer!!
There is a thread with common problems and issues.
Mechanical & Maintenance / Engine & Transmission Today 11:25 AM
thegoat86
You got a 50/50 chance. But even if it hit the pan, I would pull the pan and try to get it out for piece of mind.
Mechanical & Maintenance / Engine & Transmission Today 08:16 AM
Depends usually on lots of things. How worn the crank bearings are, pump health, plugged or slightly plugged oil passages, oil temp, ect. Too many to things worry about. As long as its around 20,...
thegoat86
Thread Starter
Mechanical & Maintenance / Engine & Transmission Yesterday 09:04 PM
I bought a built 83 k5. (see sig) Truck had overheating issues so I couldn't really road test and vett out the truck. I fixed the overheating issue. Once streetable, I noticed the trans stopped...
Performance & Brainstorming / Engine & Internal Yesterday 08:25 PM
I think the only 2 issues you have for boosting is compression ratio and piston ring gap/tolerance. Make sure to install a boost regulator or blow off valve to control boost pressure. Google turbo...
General / General Chat Yesterday 03:06 PM
Dang! Do you have a 4wd or 2wd model? I think I heard that taking off the oil pan on a 2wd model is not that hard. My first instinct would be to remove it. But if it fell to the bottom of the oil...