Question about getting cold air to the CAI.
#1
Question about getting cold air to the CAI.
So once I get my K&N filter in, I'm going to seal off the bottom of my heat shield to try and minimize the amount of heat getting to the filter, but I'm just worried about the amount of air coming from behind the headlight and through the rad support at the front.
Anyone setup some sort of piping to route cold air in there?
I'm open to any ideas, I'm thinking of rigging up some sort of scoop, but don't know if I should grab the air from behind the grille or my driver's side tow-hook and go up from the bottom.
I may be unknowingly building a dirt/dust scoop too so I'm kind of hesitant. (I don't do much off-roading, I have an ATV for that.)
Any ideas would be appreciated.
Thanks,
Anyone setup some sort of piping to route cold air in there?
I'm open to any ideas, I'm thinking of rigging up some sort of scoop, but don't know if I should grab the air from behind the grille or my driver's side tow-hook and go up from the bottom.
I may be unknowingly building a dirt/dust scoop too so I'm kind of hesitant. (I don't do much off-roading, I have an ATV for that.)
Any ideas would be appreciated.
Thanks,
Thread
Thread Starter
Forum
Replies
Last Post
chris015
1st Generation S-series (1983-1994) Tech
9
09-05-2009 10:51 PM
ravenhurst
2nd Generation S-series (1995-2005) Tech
15
04-26-2009 07:53 AM
dimmuborgir6nik6
Engine & Transmission
1
10-02-2008 06:51 AM