GMC Jimmy s15 help asap
#21
nevermind, that is the return line, gonna just double clamp it like it is on the old one, started raining, gonna be sunny tomorrow.
#22
Should be fine double clamping it, but if you really want to get crazy... two options:
1) Buy replacement line. This is available from LMC (I used them for mine) and I beleive RockAuto.
2) Make your own out of flex line. You should be able to get some AN-6 flex line and fittings to make your own replacement for the rubber line. This might be cheaper in the short run, but adds a lot of fittings.
If it were mine, I'd stick with the previous hack job and just double-clamp like you mentioned.
1) Buy replacement line. This is available from LMC (I used them for mine) and I beleive RockAuto.
2) Make your own out of flex line. You should be able to get some AN-6 flex line and fittings to make your own replacement for the rubber line. This might be cheaper in the short run, but adds a lot of fittings.
If it were mine, I'd stick with the previous hack job and just double-clamp like you mentioned.
#23
Yeah. I am just going to do what he did previously and double clamp it, being the return line its not under a lot of pressure, so I am not worried about it, now if it was the supply line, the jimmy would be out of commission for longer while i replace the whole line LOL!
#24
Jimmy is back alive! Thanks for the help everyone!
Thread
Thread Starter
Forum
Replies
Last Post
Wexinlo
1st Generation S-series (1983-1994) Tech
26
04-09-2011 03:37 AM
Advantage049
1st Generation S-series (1983-1994) Tech
11
02-11-2011 04:59 PM