Hey all! First post here but been around a lot of forums so I'm actively searching before I ask. Here's my problem, I have a 84 that I just replaced the rear u joint in. The old joint had a thin piece of metal tacked to each cap and ran across the width of the u joint. I installed the replacement and noticed the yoke did not have any tabs from the factory. I went down the road and caps slung out and driveshaft fell out. I gotta get this going by Monday so I can get to work. Any advice?

 

Please disregard this post. I meant to post this in the k5 section. I can't find the delete button