uhh. horn keeps blowing after key cylinder replacement
#1
12-04-2011, 09:15 AM
uhh. horn keeps blowing after key cylinder replacement
Finally got the dreaded key cylinder replaced. I placed the horn cover back on and the horn goes off until i remove it....what the heck? I temperarily removed the wire under the button till i figure this out..
#2
12-04-2011, 09:29 AM
Super Member
Maybe your steering wheel thinks its in a game of Operation?
Something must not have been put in the correct place. I Remember going through something similar when I took my wheel off to align it better.
I can't remember what it was though. But it sounds like its some sort of short with the horn wire.
Something must not have been put in the correct place. I Remember going through something similar when I took my wheel off to align it better.
I can't remember what it was though. But it sounds like its some sort of short with the horn wire.
Thread
Thread Starter
Forum
Replies
Last Post
Tuna
2nd Generation S-series (1995-2005) Tech
2
03-26-2022 02:32 PM
Tuna
2nd Generation S-series (1995-2005) Tech
2
07-20-2014 06:45 PM
chris015
1st Generation S-series (1983-1994) Tech
3
12-01-2011 08:44 PM
macdaddy25177
2nd Generation S-series (1995-2005) Tech
4
02-13-2011 02:07 PM
jmax31
2nd Generation S-series (1995-2005) Tech
8
04-27-2009 12:49 PM
