ok so the zr2 i got for a 300.00 four wheeler, but it threw 2 rods. getting the motor is nothing installing is nothing, but i absolutely have no clue of what im getting into with lifted vehicles, it has 15 in rims with 35 12.50's on it. flow master dual exhaust. it also has a diy made 4" body lift, aluminum deep dish rims 15x10's i think.... it is a 3dr but i have a child (2) and i need a bench for the back instead of the one in the door..... (ideas please) clears pealing but i like the satan red.

now for the 95

its been a project for a yr. with a 2000 4.3l vortech and a 95 4l60e transmission it is 4wd its 2dr. but this combination equals no flywheel dust cover... i just installed 325/60 r15 m/ts on it they clear except on sharp turns but then again i haven't drove it yet.... everything on this vehicle is new except the body/interior but that'll change. (leather) there is no lift on it even though it does expose a little frame and fit the wheels with more then enough clearing about 1.5" on the corners. the tires are on the stock 95 4x4 wheels i dont know the offset but i would like to change it so they sit out further. (motor trans is all stock all accessories to them are new "all") HAD LOTS OF THOUGHTS ON TURBOS FOR BOTH RIGS. but my lady will be using the blazer as a daily but we dont travel far or do hardcore off roading we might trail ride slowly and take a scenic path from time to time. ide like to keep nice wide tall tires on it with out a huge lift making it hard on them getting in and out....... float ideas float hey man your getting in over your head or hey u shouldnt this or def. do that you know.... lol ya'll have a good one and ill keep updated with post and pics..... im starting a car club called carolina head turners.... and i got to get these rigs rolling cant run sht if i dont have sht lol

"im not rich or do i have alot of means, but by all means i will make it happen"

 

I like the pickup