Gas charged lift support
#1
Gas charged lift support
Sorry if this is in the wrong forum. I just purchased 2x of the above. My old ones are shot and looking at this thing, I have no idea how to actually take the old ones off and put the new supports on. Is there a tutorial on this or could someone please shed some light for me on how to do this? Thanks in advance for any help.
#2
RE: Gas charged lift support
I assume you're talking about struts for the back glass, but do you have the liftgate or tailgate model?
#3
RE: Gas charged lift support
Rriddle3,
yes, the struts for the back glass. I have the tailgate model.
yes, the struts for the back glass. I have the tailgate model.
#4
RE: Gas charged lift support
Open the glass and support it.
On the top end of the strut, take a screwdriver and pry off the retaining clip and slide out the retaining pin.
On the bottom end of the strut, pry off the retaining clip and pry off the lower end from the ballstud.
Installation is the reverse.
On the top end of the strut, take a screwdriver and pry off the retaining clip and slide out the retaining pin.
On the bottom end of the strut, pry off the retaining clip and pry off the lower end from the ballstud.
Installation is the reverse.
Thread
Thread Starter
Forum
Replies
Last Post
TigaHotty85
Lighting & Electrical
16
06-17-2013 03:10 PM
pmezo
2nd Generation S-series (1995-2005) Tech
12
07-17-2012 01:29 AM
black4x4blazer
2nd Generation S-series (1995-2005) Tech
3
07-15-2010 02:06 PM