1997 4wd Issues/Fixes
#21
So after taking a break from working on my car I got back to it today. I changed the vacuum switch on the transfer case. I grounded pin 13 to run the diagnostics. I am getting DTC 2: encoder fault.
This will be the third encoder motor that has been in the vehicle. It was working for a short time, I could hear the encoder motor engage the transfer case and now nothing.
With my car in drive my 2hi light does not light up anymore and nothing happens when I push the 4hi light. When i put the car in neutral and push the 4hi light both the 4hi and 4lo lights will flash but no action from the encoder motor.
I guess its time to switch the motor again. Have any other suggestions?
This will be the third encoder motor that has been in the vehicle. It was working for a short time, I could hear the encoder motor engage the transfer case and now nothing.
With my car in drive my 2hi light does not light up anymore and nothing happens when I push the 4hi light. When i put the car in neutral and push the 4hi light both the 4hi and 4lo lights will flash but no action from the encoder motor.
I guess its time to switch the motor again. Have any other suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
ABN31B
2nd Generation S-series (1995-2005) Tech
38
01-22-2024 11:46 AM
94driven
1st Generation S-series (1983-1994) Tech
1
11-14-2009 12:43 PM