Just installed a new motor and module..at first it would come on, but the output shaft was not rotating.

I took the motor out, took off the back cover and tested it. The motor worm drive shaft was spinning, but not engaging the round drive gear.

I noticed the casing where the motor bolts on, seemed out of whack, I filed about 3/32 off one side to make it closer to 90 degrees.



Worked perfect, installed it, works but it only has 1 speed, and it will not park....
All the rear interlocks work perfect...

Anyone have a wiring diagram from the module to the motor,{5 wires} I think the park circuit works off of a ground of some sort.

Any help will be greatly appreciated...

PS..why are their 2 left front tires, on the Blazer in the page header photo..
252