help,how to line motor encoder to transfer case shalf
#1
08-27-2012, 07:58 PM
help,how to line motor encoder to transfer case shalf
1998 jimmy s10
are there only 3 positions on the shaft?
is a motor encoder now junk if hooked-up(wire bolted in) and turned(using push buttons on dash,has 3) without
being bolted in position?
thaNKS FOR ANY HELP
are there only 3 positions on the shaft?
is a motor encoder now junk if hooked-up(wire bolted in) and turned(using push buttons on dash,has 3) without
being bolted in position?
thaNKS FOR ANY HELP
Thread
Thread Starter
Forum
Replies
Last Post
LesMyer
2nd Generation S-series (1995-2005) Tech
38
01-09-2020 11:45 AM
indybuckeyefan
Engine & Transmission
0
05-31-2013 08:25 PM
LowLife
Article Submissions/Discussions
0
09-23-2011 10:46 PM
