Ignition Switch Replaced - Same Problem...
#1
Ignition Switch Replaced - Same Problem...
i did exactly what you told me to do and my truck still doesnt run!!!!!!!!!!!!!!! what do i do it has the same exact problem with the new ignition starter switch. security light blinking and no start. what do i do now?????????
#2
*Moved from the How To: Ignition Switch Replacement DISCUSSION thread into a new thread in the 2nd Gen Tech section* - The Article Submission/Discussion forum is only for submission of articles and discussion of said articles and is not meant for tech support.
Did you do the security relearn which is required after replacing the ignition switch?
*EDIT* - I see that there was a problem with the link to the passlock relearn in the tech section. I have fixed this issue. Give that a try.
*EDIT* - I see that there was a problem with the link to the passlock relearn in the tech section. I have fixed this issue. Give that a try.
Thread
Thread Starter
Forum
Replies
Last Post
rviolette84
Engine & Transmission
4
02-10-2013 07:23 PM
mikepro
2nd Generation S-series (1995-2005) Tech
4
08-15-2011 07:03 PM
jbcollection
2nd Generation S-series (1995-2005) Tech
1
02-14-2010 07:22 AM