You could try a local Chevy dealer for the bolts. They may not be as expensive as you think. Of course I tried to get a caliper bracket bolt for my blazer and it was $38.

 

hey what about the one from ebay that I linked. Would they fit

 

somehow I missed the link. They look like they should work.

 

Ok thanks. I will be posting more pictures later on when I get time. I work at continental tire and the overtime there is kicking my ***.

 

Pretty Good For $400
Pictures:

 

So after work today I'm going to be lifting the front body up from the frame to gain access to the grounds and the bell housing bolts I will post pictures of it.

 

The red spacer under the throttle body: if you remove it, you might get a little better performance

 

Lol yea i don't think that throttle body spacers work but hey its on there why not leave it. I tried removing the body mounts they just kept spinning so I gave up on them and i just hooked up about four grounds to a bolt on the back of the passenger side cylinder head.

 

So I have a couple questions On some stuff


Where does this vacuum line connect to



Also What is this. I think its a engine block plug. If so what size of plug do I need.

 

the second picture is for the temperature sender sensor