2000 Blazer 4x4 "trailblazer" 4.3 vortec (not the straight 6)...

So I'm changing out the gasket and seal on my oil cooler block-to-lines adapter... i have to somehow get the old gasket off of the block. There was so little clearance that i had to both raise the engine a little and disconnect the front driveshaft to get the adapter out of there.

My question is does anybody know any protricks to get the old gasket outta there? Is there a special $35 tool i need to buy?

Thanks for reading!

 

meh. i used a large flathead,that i grounded the end super flat/sharp. and also bend the end of a sharp knife. it just takes time. lay down,turn on some music,and grab a beer,enjoy.

 

Ok thanks for the advice man! I figured i might end up doing some tool customization 8-)

 

Got it! Sharpened a flathead like you said... then wedge and twist and wedge and twist and wedge and twist. Nice and clean. Thanks again for the help!

 

woot!