Stuck in 4Lo - vacuum actuator?
#11
RE: Stuck in 4Lo - vacuum actuator?
ORIGINAL: ejp
The problem is, I didn't take it out myself. I was asked where that upper tube (in the picture, by the engraved numbers) is supposed to go. Does anyone know? Pictures would be nice if applicable.
The problem is, I didn't take it out myself. I was asked where that upper tube (in the picture, by the engraved numbers) is supposed to go. Does anyone know? Pictures would be nice if applicable.
#12
RE: Stuck in 4Lo - vacuum actuator?
You dont look around much do you??
It goes to the vacuum switch on the transfer case.
As I have posted in quite a few other threads on this exact same subject, I will post it here in hopes that someone else may actually see it.
Here is the vacuum diagram which is used on the NV231 and NV233 transfer cases:
AND:
It goes to the vacuum switch on the transfer case.
As I have posted in quite a few other threads on this exact same subject, I will post it here in hopes that someone else may actually see it.
Here is the vacuum diagram which is used on the NV231 and NV233 transfer cases:
AND:
Thread
Thread Starter
Forum
Replies
Last Post
markrd
2nd Generation S-series (1995-2005) Tech
4
05-08-2009 01:39 PM
Alterac
2nd Generation S-series (1995-2005) Tech
5
08-25-2008 08:48 PM