time to rip some door panels out
#1
Hey all:
I am a proud owner of a 2000 ZR2 and I am upgrading my stereo system myself. I have purchased Pioneer 4x6's, and 6 3/4's for the front. The previous owner disconnected (or the OEM radio stopped giving power to) the back 6x9's. It may have been a good thing, to share more power to the front speakers. I will probably keep the same set up and wire an amp for the back speakers at a later time.
My question is do I need to take off the front door panel to access the speaker? or do the covers just snap off?
Many thanks!
Eric
I am a proud owner of a 2000 ZR2 and I am upgrading my stereo system myself. I have purchased Pioneer 4x6's, and 6 3/4's for the front. The previous owner disconnected (or the OEM radio stopped giving power to) the back 6x9's. It may have been a good thing, to share more power to the front speakers. I will probably keep the same set up and wire an amp for the back speakers at a later time.
My question is do I need to take off the front door panel to access the speaker? or do the covers just snap off?
Many thanks!
Eric
#2
The whole panel has to come off, it's all one piece. Good luck too because after you remove it you're almost guaranteed to have a rattle
#3
Starting Member
Join Date: Dec 2009
Posts: 178

damn... more rattle. my 97 also has the back speakers ut off.. no idea where so id figure id look in the door aswell...
#4
Thread
Thread Starter
Forum
Replies
Last Post
Diablo1982
Paint, Body, & Interior
3
02-27-2011 07:38 AM
rickyp3278
Headers, Intake, & Exhaust
3
04-14-2008 04:52 PM







