the coil and bonnet

the beastly supercharger

tried to get a shot of the electric fans

the msd ignition

 

i did all the installation myself so if it looks a little sloppy shoot me but there is no doubt the power is there now if i can figure out how to upload video i might get a burnout vid on here lol

 

A few pics of the serpentine belt routing and the charger mounting bracket would be great...

 

Looks good Dan, WTG!!! I like the aluminum bonnet you got, looks sharp! The rubber connectors/elbows, are they carbon fiber look-a-like?.
As for the 'look of sloppyness' some split wire loom & zip ties will take care of that.
I think I have pics/vids of that in the Nitrous/Supercharger & Turbo's section in What to call this thread... Dan & I have the same supercharger. In his previous posts in this thread there's a pic or 2 of the parts, just not of the belt with the cog drive hooked up.

just saw the aluminum blow off valve as well, very nice.

 

the aluminum blowoff valve is part of the high pressure bonnet upgrade and i will get those wires tied up and in some flex conduit after all the hours i spent doing the install i was ready to get her out of the shop i still have to change my spark plugs,wires and a radiator flush and then there are the 2 superlift shocks for the rear

 

blacked out my tails with vht nightshades but my pic got screwed up

 

nice!!! im doing this next weekend if its warm enough

 

well i got my 8.5 mill wires installed today and my plugs i changed the ones on the driver side fender well piece of cake plus i got my wiring for my my fans and ignition all tidy now i will get some pics on tomorrow

 

wires all tidy

 

tinted tails soon doin front ambers