Ya mine jest drooped like 3 inches im re placing all the factory supports and than bracing the bed floor with 1inch square steel i got a new clip for it and some quarter panel patches this blazer aint as bad as my first to my old 82 k5 it drooped 5 inches on the driver side and some one stuck 3inch lift blocks on the driver side only to make it look right but it didn't drive right it was a mess i drove it in to the ground it lasted 4 years

 

Well i finely got some work done theirs more rust then i thought i got the body strait in the rear end the support that the gate hinges mount to are shot im going to re place it with some i beam im going to all fab in the morning to get that made up, im having trouble getting the body back up in the front its sagging about one inch iv ran out of ideas any one got any

 

When I did my interior, I DREADED pulling up the carpet. Once I finally got the nerve, I found all kinds of holes. I paid a bodyshop $700 to repair the holes, put in new steel, and re create the channels where the lower door weatherstrip clings onto....after that I had the entire interior sprayed with bedliner.

 

Ya im making pretty good progress i all most have the back bed done ill post some pics Wednesday

 

Nice project so far, really makes me miss my 84 Sierra.

Just a tip for your thread, when you submit the pics, (especially when theres eye candy involved lol) insert a line between each picture with the enter key so they're on top of each other instead of in a horizontal line.

 

keep plugging away. i picked up the cab and the bed together when i did mine. held everything in place while i cut out old supports and re-welded new in