97 4.3 timing problems
#1
97 4.3 timing problems
ok so i have been trying to get my timing right and i have done all the steps in the edi timing post , but it seems like when i put my dist in the rotor is either in front of the small 6 on the dist or if i take it one tooth back its behind the 6 . it seems like wherei want to be is between the 2 teeth . the truck start in both ways but runs like crap . plz help thanks
bump... could i have it 180 off or would it not run at all?
bump... could i have it 180 off or would it not run at all?
Last edited by dirty420; 06-19-2011 at 09:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Doctorvette
1st Generation S-series (1983-1994) Tech
10
11-05-2012 11:57 PM
Denominator
Engine & Transmission
0
09-23-2010 02:40 PM
hotrodln
2nd Generation S-series (1995-2005) Tech
17
04-26-2010 07:32 PM
Denominator
Engine & Transmission
10
04-25-2010 06:31 PM
dlockett999
2nd Generation S-series (1995-2005) Tech
1
12-14-2008 05:39 PM