encoder motor wont line up with shaft on transfer case
#1
encoder motor wont line up with shaft on transfer case
hi all
i bought a transfer case from the junkyard which didnt have encoder motor on it.
i removed the motor off my core and wanted to bolt on new one ,but even with both in 4hi position the shaft doesnt line up with slot in encoder motor.
i can spring the shaft maybe 10 degrees past 4hi but even that wont get it.
thanks in advance.
didnt think it would be so diffulcult!!!!!!!!!!!
sorry forgot to mention
99 jimmy with 236 transfer case
auto 4wd
i bought a transfer case from the junkyard which didnt have encoder motor on it.
i removed the motor off my core and wanted to bolt on new one ,but even with both in 4hi position the shaft doesnt line up with slot in encoder motor.
i can spring the shaft maybe 10 degrees past 4hi but even that wont get it.
thanks in advance.
didnt think it would be so diffulcult!!!!!!!!!!!
sorry forgot to mention
99 jimmy with 236 transfer case
auto 4wd
Last edited by indybuckeyefan; 05-31-2013 at 08:49 PM. Reason: didnt mention make/model
Thread
Thread Starter
Forum
Replies
Last Post
LesMyer
2nd Generation S-series (1995-2005) Tech
38
01-09-2020 11:45 AM
int3414
2nd Generation S-series (1995-2005) Tech
0
08-27-2012 07:58 PM
LowLife
Article Submissions/Discussions
0
09-23-2011 10:46 PM