Engine & Transmission Post your Engine and Transmission related problems here.

need help with my 92

Old Feb 16, 2009 | 06:45 PM
  #1  
clinton3119's Avatar
Thread Starter
Joined: Feb 2009
Posts: 8
clinton3119 is an unknown quantity at this point
Default need help with my 92

tonight i replaced everything in the hei distribitor, and it still backfires out the tbi. only codes im getin here now are 42 44 45 im running broke and need this blazer for work please help!!!!
 
Old Feb 16, 2009 | 06:51 PM
  #2  
c0a8l0v6i8n9's Avatar
Junior Member
Joined: Jan 2008
Posts: 296
From: Long Island, NY
c0a8l0v6i8n9 is an unknown quantity at this point
Default RE: need help with my 92

42 – Bypass or Electronic Spark Timing circuit - The EST signal did not change when the ECM applied bypass voltage to the ignition module.

44 - Oxygen sensor or circuit – lean exhaust detected. - Oxygen sensor voltage was under 0.25 volts for up to 4 1/2 minutes of closed loop operation.

45 - Oxygen sensor or circuit - rich exhaust detected. - Oxygen sensor voltage was over 0.750 volts for 2 minutes in closed loop operation with a throttle angle between 0.6 and 1.9 volts.

I dont think your oxygen sensors would cause that backfire
 
Old Feb 16, 2009 | 07:05 PM
  #3  
clinton3119's Avatar
Thread Starter
Joined: Feb 2009
Posts: 8
clinton3119 is an unknown quantity at this point
Default RE: need help with my 92

im not sure what to do with it, it has got worse in the last couple weeks, doesnt mater what i change on it, im strartin to lean toward faulty ecm! but not sure couse it never stalls out
 
Old Feb 16, 2009 | 08:19 PM
  #4  
swartlkk's Avatar
Administrator
Joined: May 2005
Posts: 41,331
From: Waterloo, NY
swartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond repute
Default RE: need help with my 92

Lets start with what you have already done...

How does it run with the O2 sensor disconnected?
 
Old Feb 16, 2009 | 08:37 PM
  #5  
clinton3119's Avatar
Thread Starter
Joined: Feb 2009
Posts: 8
clinton3119 is an unknown quantity at this point
Default RE: need help with my 92

sorry my pc died! runs the same on or off! we tryed that saturday night. i was readin that a fpr can drip fuel into the intake cousing a backfire im not ruleing anything out, but it does just seems to be more electical than simple macanical if im running highway speed it does pritty good till i have to put it on a load! thats when it starts to pop, but its not missing under a load at a stoped point!
 
Old Feb 16, 2009 | 08:45 PM
  #6  
clinton3119's Avatar
Thread Starter
Joined: Feb 2009
Posts: 8
clinton3119 is an unknown quantity at this point
Default RE: need help with my 92

it allso stinks out the tail pipe (very raw) and smells very gassy under hood right after shut down. i know also before it started popping on me the check light would comeon and id loose power like it was flooding, shut down and restart would cause a thick blue smoke for bout 2-3 sec. i was geting code 42 and 44 then,but now its the outher way around, it runs better with the light on less popping and now adding 45 to the sequnce!
 
Old Feb 17, 2009 | 09:14 AM
  #7  
c0a8l0v6i8n9's Avatar
Junior Member
Joined: Jan 2008
Posts: 296
From: Long Island, NY
c0a8l0v6i8n9 is an unknown quantity at this point
Default RE: need help with my 92

Try unplugging the map sensor and see if it stalls or not
 
Old Feb 17, 2009 | 06:52 PM
  #8  
clinton3119's Avatar
Thread Starter
Joined: Feb 2009
Posts: 8
clinton3119 is an unknown quantity at this point
Default RE: need help with my 92

yes it stalls, we seam to have got rid of the poping, it was advanced too far my dad said , but still kicks the light and runs like its flooding with NO power till i restart at a roll!
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
1hugeblazer
General Chat
7
Feb 21, 2011 06:05 PM
maximashift
2nd Generation S-series (1995-2005) Tech
1
Nov 17, 2009 09:36 AM
maximashift
Engine & Transmission
1
Nov 17, 2009 09:33 AM
blazin4eva
Audio/Video Electronics
1
Jan 27, 2005 02:02 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 05:26 AM.