Let me give the whole story. I have a code that says high RPM detected. I changed the IAC, TPS, New timing chain, Cleaned the EGR, new plugs, wires, distributor, rotor, cap, Crank position sensor and it still shows the code. It runs great except for at a stop it rough idles for 3 - 4 seconds and then is fine. During the rough idle, the oilpreasure gauge is going crazy and then it goes normal. Any ideas?

 

No need to post another new thread... You have everyone's attention in your other thread on this... Is this True


*Thread Closed - Duplicate Post* - Please respond to the thread linked to above. Thanks!