So i finally got around to installing my cb radio, i couldnt find a whole in the fire wall to run the wires through, so i just made my own whole. now my delema is where to hook up my PA speaker, any ideas. my friend suggested on top of the rack, and i am actually considering it.

 

I put mine in the grill. I had it in the engine bay, but it wasn't as loud. It fit perfectly behind the grill in my 96. You can hear it perfect and it is hidden very good.

 

Yeah I would say behing the grill or behind where the lisence plate goes.

 

how would i put it behind the grill, would i have to take the grill out, i just ran out there and it dosnt look like theres a spot to put it in through the engine compartment

 

put it in the grill you can mount it right by the bumper. you can barely see it and its nice and loud. you can barely see the tip of it right below the g in this picture.

[IMG]local://upfiles/7265/67BCF7DF7B9F454C8BCBD707EC0488C4.jpg[/IMG]

 

thanks man, how doi get it behind the grill, do i have to take the grill out or am i missing something, because when u open the hood, there is that bar going across and nowhere to put it through?

 

yea you have to take out the grill. there is a spot between the bumper and radiator that you can mount it to.

 

I didn't take the grill off. there was a plastic piece that goes around where the hood shut. there were two pins holding it on. pulled the pins out and pulled the plastic piece off. then just found a place to screw into. took like 5min.

 

i put mine down here so it is more hidden. took this when installing my body lift

[IMG]local://upfiles/7265/22691CA6B4BB4C6CB7DFA142EFA6A92F.jpg[/IMG]