Put in $ 1,720.00 between June 10 & June 16

Just about done with priority replacements/services.
***then the fun stuff like light bars, lift kit etc...

-----DONE--------
CV Axle - Left Front
Differential Flush
Fuel Injector service
Idler Arm
Inner Tie rods
Outer Tie rods
Pitman arm
Rear Pinion seal
Steam clean Suspension / Engine/ Trans ** Shop did Free **
Sway Bar Links ** Shop did Free **
Trans flush service
Trans Pan Gasket
Wheel alignment

 

I got the original untouched factory trailer wiring hooked into my LED Bow tie hitch cover today.

 

Nice looking Blazer there wow mine is a 2001 wish it looked this great.

 

Thanks it was very well taken care of by father to son hand down,
now I am doing my best to keep it up...Not bad for 1500.00 bucks.
I just dropped at shop a hour ago to get the A/C service done,
Radiator flush service and Transfer case fluid changed.

 

Got the Transfer case fluid changed, Radiator flushed and A/C Service done.

Then I blew some cash in a online ordering spree..Lol...
Ordered A Stainless Steele push bar...LED Light bar..
a hood deflector... all 4 window vent shades... a Kenwood Receiver,
4 Alpine door speakers...a Pyle Chopper series amp and Pyle Full Range speaker box, ..Front and Rear SANDBLAZER top Window graphics...all new floor mats and cargo mat.....Then I took a Nap...Lol

Graphics for top of front & rear window:

 

Pyle isn't a good brand, but if louder at the cheapest price is what you're looking for then I suppose it fits the bill.

 

I agree, Pyle receivers and regular door speakers I never cared for thats why I went with Kenwood and Alpine

..but this small Pyle amp driving the Pyle dual 8 inch full range box is a good match and is clear crisp sound I matched up by trial and error over several years.....or it could just be I have superior amp tuning skills ...Lol

 

Meh, if it makes you happy that's all that matters.

 

6/23 -Today got the Sound system upgrade installed.

 

Working on installing a cleaned/rebuilt/modified slightly spare tbi unit. Shaved the throttle shaft a bit, removed horns from top, pod spacer, fuel pressure gauge. Cleaned it the best I could, hopefully see some positive improvements.