I went to work and ask my boss to see if I can use the sand blast to do my tow hooks this weekend and he told me no because no other project from outside of the work place. So I am going to have to figure out how I can get the rust off it and prime, then paint it black this weekend.

 

my 1st decent cell with a camera was a Sony cell & they basically built a cell phone around a Sony Cybershot 5MP camera. Friends were amazed at the pics, how fast I could roll them off. Now I have a Android phone, 8MP I think, maybe a 5 or 6MP but it takes CRAPPY pics!!
Do you want to buy a Sigma 14.2MP DSLR? paid over $2300 & only 260 pics on the camera plus a chit load of extras. lol I use the blazer more than the DSLR so the DSLR has to go.

What was OP again? Oh yeah what have bla bla... I drove it - that's a bonus with a bent DS upper control arm & a outer tie rod end, not to mention a connecting rod bearing or wrist pin shot. It got me to work n back... groceries & beer ta boot! Just have to work out that gremlin of the key stuck in the ignition. Read about the switch, commented on a couple too, but I can give my column an upper cut & the key is free, not shifter then I'd assume.

 

Wow. Those do look sweet black! I wonder what it would look like bed lined?

 

shhweeet

 

I would go with both colors, that would add more power than if you just used one.

 

ok last night i got the engine running. took two days to get it timed i keep using the wrong timing mark on the pulley so i got my compression gauge and bore scope out got to #1 compression had to move the piston a little more for top dead center. found out the harmonic balancer had two marks on it. i felt stupid i dropped the distributer in three times before i got it right. got the lift kit in the front, tonight i will get the rear done. got new wheels in on Friday hussy have to get new tires. then off to the shop for front end alignment get super Chip on mon will install it then. this $900 blazer 99 will cost about $3500 Webern said and done

 

I got some work done on the leds today.

My soldering has gotten bad, I blame the crappy soldering iron I'm using.


Here is the style I'm going to do. The outer ring will be the running and the rest are the brake/turn.

 

primered my inside tailgate piece to get ready for painting it im bad at taking pics ill try to do that more often

 

I drove 14 miles to work and 14 miles back home. Well I can't use the sand blast machine at work to do my tow hooks. So what can I do now because I want to repaint them black because I am going black out on my Blazer.

 

Rust/paint stripper disc in a drill will clean them up.