what have you gotten done on your blazer today?
#7023
got my winter wheels back on the road. i have been joyriding in the mustang for a month.
gave her a bath and full tank of fuel. also freshened up the interior.
glad to be back in the high ride again.
gave her a bath and full tank of fuel. also freshened up the interior.
glad to be back in the high ride again.
#7028
If a DTC is present it may have to happen more than a few times in order for the PCM to light the CEL. This is normal for operating temp, 02 sensors etc. Things that may not get to proper temp in a short cycle/drive.
#7029
Of course there's really nothing like permanent success with an older vehicle. Anything can go wrong at any time. It will take several more drive cycles before I can have any sense of certainty that the P1870 won't come back.
#7030
Finally finished engine removal/installation 2.0 . Boy am I sick of working on this thing!! Yanking the engine once a year is a royal pain in the ***. Hopefully this should be the end to that ritual.
The new oil pump was a bit noisy to start out, but I didn't notice that at all until I got the exhaust hooked back up. Figured I'd better fire it up before I install the Y pipe and crossmember. None of those are fun to remove or install on this thing, because every nut & bolt has a different sized head. Gets real aggravating after you forget that detail after a year goes by ...
But anyway, here she is running but not yet finished. I never miss an opportunity to fire it up with no exhaust ...
Only thing I have left to do today is install the front skid plate, replace the heater fan switch, and see if I can't get the odometer working again.
Can't seem to figure out how to embed vids here, so here's the link. She sounds mean! Neighbors could hear it idle a 1/4 mile away.
http://s297.photobucket.com/albums/mm215/jjs05polaris/?action=view¤t=Blazerrunningagainafteroillea krepairs.mp4
The new oil pump was a bit noisy to start out, but I didn't notice that at all until I got the exhaust hooked back up. Figured I'd better fire it up before I install the Y pipe and crossmember. None of those are fun to remove or install on this thing, because every nut & bolt has a different sized head. Gets real aggravating after you forget that detail after a year goes by ...
But anyway, here she is running but not yet finished. I never miss an opportunity to fire it up with no exhaust ...
Only thing I have left to do today is install the front skid plate, replace the heater fan switch, and see if I can't get the odometer working again.
Can't seem to figure out how to embed vids here, so here's the link. She sounds mean! Neighbors could hear it idle a 1/4 mile away.
http://s297.photobucket.com/albums/mm215/jjs05polaris/?action=view¤t=Blazerrunningagainafteroillea krepairs.mp4