O2 sensor connector missing
#1
O2 sensor connector missing
I went to change my O2 sensor on my 2000 Chevy Blazer and noticed that the male connector on the driver side coming from the computer was missing. Don't even see the wiring at all.Any ideas on what to do?
Last edited by Curtis James; 12-29-2018 at 08:01 PM.
#2
Helped a buddy with a similar issue with his starter.
We went to the salvage yard and looked for the appropriate wire. Found it, followed it to the loom, and clipped it with plenty of length.
Found the same loom on his s10 pickup, and we found the broken wire. Fixed with some heat shrink, electrical tape and a new loom.
I would advise something like this procedure, but someone will probably post the wire schematics soon enough.
We went to the salvage yard and looked for the appropriate wire. Found it, followed it to the loom, and clipped it with plenty of length.
Found the same loom on his s10 pickup, and we found the broken wire. Fixed with some heat shrink, electrical tape and a new loom.
I would advise something like this procedure, but someone will probably post the wire schematics soon enough.
Thread
Thread Starter
Forum
Replies
Last Post
spittybays
2nd Generation S-series (1995-2005) Tech
9
09-17-2012 02:52 PM