Hey guys

tonight I had a small accident with my blazer and my dads s10 pickup

I sorta hit some ice and slid into him NO Harsh damage but i did dent his bumper with my brush guard

I was going to remove the bumper to knock the dent out but

I only see 3 bolts 2 on the brackets and 1 on a bar on each side

is that all thats holding it ?

 

if it

 

It got sorta dark and yes its a 2nd gen

I saw 2 on the bottom on the frame and 1 on each reinforcement bar

thats all i saw

I just wanted to make sure cause imma remove it tomorrow and its gonna suck with the snow we going to get tonight

I got so aggravated i just went inside once the sun went down

 

There should be two on top of the frame rails too.

 

alrighty thanks so its 4 bolts on each side

 

I had 1 bolt in each wheel well.. tough to get to but possible.

 

they are not hard to get off as long as you have a good pull handle and they are not to rusted on

 

yea I just got in

I was just planing ahead and I think i could have it out in 15 20 mins

Imma remove the grill to prevent headaches

 

sounds good

 

yup, gotta pull the grill, youll see 2 torx which are T50s on top, then you need about a 6 inch extension to get the two lowers, and then the two side supports to the frame