Weldless Bumper
#11
On the sides yeah, but the middle plates need to stay solid to attach the square tubing.
Change of plans, Menards doesn't carry flat steel. Home Depot doesn't carry flat steel wider than 2 inches. Farm and Fleet goes up to 3 inches, so I am going to have to deal with that.
Change of plans, Menards doesn't carry flat steel. Home Depot doesn't carry flat steel wider than 2 inches. Farm and Fleet goes up to 3 inches, so I am going to have to deal with that.
Last edited by BigEffingHammer; 03-04-2012 at 04:04 PM.
#12
#13
you can always have someone else weld it for you. i used to be in the same boat. when i did the sfa on my s10 i cut and made everything. labeled or put in place what i could and had a guy come and weld everything up
#14
Bend wise, I won't be doing insane bends. I will be putting like a 5-10 degree bend in the middle of a big piece, that's it.
I have considered that, however, I'd really like to be self sufficient plus later, I can say, I built that... Not I built that but had someone else weld it.
Thread
Thread Starter
Forum
Replies
Last Post
mike97blazer2DR
Paint, Body, & Interior
6
07-04-2005 11:10 AM