96 Fuel Pressue
#21
I went with the Eichlin, hopefully it holds up, this is not what I would call my favorite activity lol. Based on what I can tell the stock bracket "should" work with this upgrade. I ordered the other one just in case. Ill let you know how it turns out! Thanks again for all of your help.
#23
OK I have it installed. I fired it up, and it went bananas, like it REALLY came alive, im talking 3500 rpms or more, I had to shut it down. Anyway there is a vacuum leak. Its coming from whatever the break booster line goes to on the plenum, I can not figure out that that part is called. It will not sit properly back down and twist in, I think it needs replaced. Do you know what that is called?
***UPDATE** I finally figured out what it was called. its this part number 12602245 Power booster brake vacuum tube fitting.
***UPDATE** I finally figured out what it was called. its this part number 12602245 Power booster brake vacuum tube fitting.
Last edited by coastie; 05-14-2024 at 09:21 PM.
#24
On second attempt, some WD40 got it to slide right in, almost like it was made for it.
It idles right around 1k, a touch under, so I'm pretty happy with that.
It still has a slightly rough idle, I'm hoping a tune up will take care of that. There could be a small vacuum leak somewhere I missed as well.
It idles right around 1k, a touch under, so I'm pretty happy with that.
It still has a slightly rough idle, I'm hoping a tune up will take care of that. There could be a small vacuum leak somewhere I missed as well.
Thread
Thread Starter
Forum
Replies
Last Post
majik211@yahoo.com
Engine & Transmission
12
08-23-2012 04:21 PM