belt number needed to bypass air pump 85 s10 blazer with serpentine belt
#1
belt number needed to bypass air pump 85 s10 blazer with serpentine belt
not really sure what forum this should go in but i got a 85 s10 pick up 2.8 engine and after ordering 5 different belts and trying to install them finally
gates - k040476 will work.
they dont really make a specific belt to bypass it so i had to do some measuring and ordering. figured id post this up for future searches
gates - k040476 will work.
they dont really make a specific belt to bypass it so i had to do some measuring and ordering. figured id post this up for future searches
#2
Um what serp belt setup you got (f-body/s-series) and are you running underdrives might be some helpful info.
Personally I was running a 2nd alt down there but redoing my factory one with a bigger one and thinking of running an engine driven air compressor for on board air and a set of train horns, lol.
Personally I was running a 2nd alt down there but redoing my factory one with a bigger one and thinking of running an engine driven air compressor for on board air and a set of train horns, lol.
Thread
Thread Starter
Forum
Replies
Last Post
Psychropod
2nd Generation S-series (1995-2005) Tech
17
09-16-2018 03:05 AM
Bob_55
2nd Generation S-series (1995-2005) Tech
5
10-29-2015 10:43 AM
gomfrddy
1st Generation S-series (1983-1994) Tech
1
09-03-2011 05:44 PM
tcad
The Lounge
7
08-15-2011 08:24 AM
ChevyHick01
Engine & Transmission
3
06-18-2011 06:27 AM