God dang Blazer!!!!
#1
God dang Blazer!!!!
My 91 Wouldnt start the other day was getting no fuel, so i replaced the filter and had fuel all the way upto the injectors but none coming through them, so i replaced the injectors now i got gas coming all the way up but when i hit the key it pi$ses everywhere and only a little comes out the injectors. now my question is should i replace the gasket for the t/b beings thats where it comes out of? would the problem be that its not getting the aloted 600psi to the injectors to start the truck? i'm getting so dam tired of this thing its been sitting for to long if anyone can help me out i'd appreciate it.
Thanks.
Thanks.
#2
RE: God dam Blazer!!!!
PM sent.
#3
RE: God dam Blazer!!!!
600psi... No s-series truck requires that kind of pressure... A TBI motor requires 8-10psi.
If you have fuel spilling out all over the place, it sounds like you need to replace the horn gasket on the TBI unit.
If you have fuel spilling out all over the place, it sounds like you need to replace the horn gasket on the TBI unit.
#4
RE: God dam Blazer!!!!
ORIGINAL: swartlkk
600psi... No s-series truck requires that kind of pressure... A TBI motor requires 8-10psi.
If you have fuel spilling out all over the place, it sounds like you need to replace the horn gasket on the TBI unit.
600psi... No s-series truck requires that kind of pressure... A TBI motor requires 8-10psi.
If you have fuel spilling out all over the place, it sounds like you need to replace the horn gasket on the TBI unit.
Thread
Thread Starter
Forum
Replies
Last Post
Elite Kustoms
2nd Generation S-series (1995-2005) Tech
9
06-16-2017 05:40 PM