no start
#1
no start
just got my car back together from a head job and now it wond start.
i had replaced both of my heads on my blazer and now it wont start. i torked the rocker arms to 20 foot pounds but in no order or any thing i just went at it. the motor has fuel and spark and the fireing order is right so throw out some ideas
i had replaced both of my heads on my blazer and now it wont start. i torked the rocker arms to 20 foot pounds but in no order or any thing i just went at it. the motor has fuel and spark and the fireing order is right so throw out some ideas
#2
RE: no start
Does it rotate and not start, or nothing at all?
#3
RE: no start
it rolls over strung but no start
#4
RE: no start
According to GM Service CD valve rocker arms should be 18lbft of torque... and the ball stud at 35lbft... also check all your electrical connections to make sure that they are tight and working...also make sure the computer connections at the computer are tight.
Thread
Thread Starter
Forum
Replies
Last Post
ejxjohnson
1st Generation S-series (1983-1994) Tech
2
09-10-2010 08:21 PM
blazerJim1701
2nd Generation S-series (1995-2005) Tech
7
07-26-2009 09:18 PM
Larhatch60y
2nd Generation S-series (1995-2005) Tech
6
11-08-2007 01:05 AM
actionpaintball
General Tech Help
9
07-14-2006 07:53 PM
apekim
General Tech Help
8
06-30-2006 10:38 AM