My 3rd brake light is out. I'm not sure if it is 'Stock' or not being that its LED's.

The other brake lights work, but this one does not. I have not troubleshooted the wiring yet, and I have no idea where the wires go.

Anyone have any advice? If I wanted to run a new wire, where would I connect? Does it connect to the switch on the brake pedal?

Jim

 

remove the cover and check for power with a test light

 

Its fixed.

There was power to the brake light, but no lighting.

I took the light off, and used a 12v source to see what was up. I disassembled the light and noticed that if I touched the power right to the circuit board, the thing lit up.

So, I guess the wires between the brake light circuit board and the connector were bad... Very weird. I put new wires in and its all fixed.