2000 Blazer LS 4 Wheel Drive Problem
#11
04-20-2013, 05:14 PM
UPDATE!
Ok, I have tried to get the trouble codes by jumping a wire from pin 13 on diagnostic connector to ground, which did nothing. No lights on 4WD buttons and nothing flashed. I disconnected battery for 30 seconds, then started car. Lights stayed off for about 15 seconds then all came back on. When key is in run position with car not running, I have no lights lit on buttons. While running, all 5 lights are lit(Auto 4WD, 2Hi, Neutral, 4Hi, 4Lo).
Ok, I have tried to get the trouble codes by jumping a wire from pin 13 on diagnostic connector to ground, which did nothing. No lights on 4WD buttons and nothing flashed. I disconnected battery for 30 seconds, then started car. Lights stayed off for about 15 seconds then all came back on. When key is in run position with car not running, I have no lights lit on buttons. While running, all 5 lights are lit(Auto 4WD, 2Hi, Neutral, 4Hi, 4Lo).
#12
04-23-2013, 09:02 PM
I'm still looking for some ideas on this. Anyone have a clue where I should go with this?
THanks,
THanks,
Thread
Thread Starter
Forum
Replies
Last Post
mirrorimij
2nd Generation S-series (1995-2005) Tech
3
06-08-2019 03:34 PM
dawnmarie515
2nd Generation S-series (1995-2005) Tech
2
08-01-2014 11:07 AM
dawnmarie515
2nd Generation S-series (1995-2005) Tech
3
09-01-2013 11:40 AM
necropenetrator
Steering, Suspension & Drivetrain
1
07-28-2012 04:11 PM
lizzj70
Steering, Suspension & Drivetrain
2
06-23-2010 06:57 PM
