aftermarket temp gauge install
#1
aftermarket temp gauge install
ok i searched around, and i have a general idea of where i am gonna place the sensor for a temp gauge....but i noticed this point as well coming out of the thermostat neck...
would that work as well? i just think it would be easier/better then teeing off the factory sending unit.
thanks guys...
would that work as well? i just think it would be easier/better then teeing off the factory sending unit.
thanks guys...
#2
That would work as well.
#3
thank you for the answer swartlkk.
i will have to do a little write up for this...i found a lot of info for oil pressure connection, but this was slim pickens at best.
i will have to do a little write up for this...i found a lot of info for oil pressure connection, but this was slim pickens at best.
Thread
Thread Starter
Forum
Replies
Last Post
warthogdriver
Article Submissions/Discussions
1
08-11-2011 08:56 PM
zakm0n
Engine & Transmission
5
01-09-2011 07:31 PM
fruggy
1st Generation S-series (1983-1994) Tech
2
03-03-2010 01:56 PM