Hey guys and gals, Ive replaced upper and lower balljoints, the tierods are good, replaced the idler and pitman arm, and the steering gear. These were all parts needed to be replaced but after that there is still a vibration almost pulsing after I turn the wheel about a full turn in any direction at slow speeds forward or reverse it still does it. I have no clue what it could be. Doesnt seem like the wheel bearings but someone also mentioned maybe the power steering pump?? I dont know any suggestions would be great

 

i have felt something similar to resistance at times while turning on a car with a bad steering pump, as it gets to a certain point and only that point. its like something grabs the wheels.

 

Check your tires could be egg shaped or out of balance tire

 

Any of the above plus a bent rim, and anytime front end components are replaced, an alignment is usually required.

 

also check that if its 4x4 it is not stuck in 4hi this on dry pavement will cause binding and jumping of front end.

 

is it vibrating or grinding in the front of the car on a specific side?