Does anyone have an overhead chassis diagram the could throw a couple arrows on in MS Paint? I hear driveshaft for 4x4 but I do not see them. I did my first greasing yesterday and only found 8 of my zerks at first. I know there's a few up under the skid plate, but I only found one on the passenger side.

If there was an overhead for both 4x4 and 2wd, combined with the above pictures would make a great DIY sticky thread.

 

Yes they do.....usually towards the front of the shaft (pointing to front of vehicle) where the yoke slides in. At least the smaller front driveshaft (4x4 setup) is a definite. Not on main if it's 1 piece.