My whits end!! TIming Problems!
#1
12-12-2008, 11:31 PM
My whits end!! TIming Problems!
I have replaced just about everything, 1995 Blazer 4x4, 209,000 miles Will not start.
VCM
Plugs and wires
Coil pack
ignition module
Crank position sensor
rotor cap and button
I have 60lbs of fuel pressure
When I turn it over a few times, All I get is a violent backfire. I have retimed it several times. I have 160 or better compression on all cylinders.
Is it possible to have this good of compression and timing chain have jumped?? HELP!!
VCM
Plugs and wires
Coil pack
ignition module
Crank position sensor
rotor cap and button
I have 60lbs of fuel pressure
When I turn it over a few times, All I get is a violent backfire. I have retimed it several times. I have 160 or better compression on all cylinders.
Is it possible to have this good of compression and timing chain have jumped?? HELP!!
Thread
Thread Starter
Forum
Replies
Last Post
Doctorvette
1st Generation S-series (1983-1994) Tech
10
11-05-2012 11:57 PM
Denominator
Engine & Transmission
0
09-23-2010 02:40 PM
hotrodln
2nd Generation S-series (1995-2005) Tech
17
04-26-2010 07:32 PM
Denominator
Engine & Transmission
10
04-25-2010 06:31 PM