passlock repro.
#1
passlock repro.
Anybody know if there is way to reprogramme pass lock without gm computer after replacing steering column or if I replace complete column with key do I still have to reprogramme.
thanks
thanks
#2
RE: passlock repro.
There sure is.
Check out this link :ww.bsecorp.com/files/techtips/ST9303l.pdf
It's a PDF of a GM vehicle computer relearn procedures. At the bottom of page 2 starts the Passlock info (kinda cool, it tells you how it works ) then the relearn procedure. I've done it on my Blazer, it's easy, just takes 30 minutes because you have to cycle the ignition timeout 3 times [:@]
And sorry to link the PDF, I would have just quoted it here but I'm on my laptop and don't have a PDF editor on here.
Check out this link :ww.bsecorp.com/files/techtips/ST9303l.pdf
It's a PDF of a GM vehicle computer relearn procedures. At the bottom of page 2 starts the Passlock info (kinda cool, it tells you how it works ) then the relearn procedure. I've done it on my Blazer, it's easy, just takes 30 minutes because you have to cycle the ignition timeout 3 times [:@]
And sorry to link the PDF, I would have just quoted it here but I'm on my laptop and don't have a PDF editor on here.
#3
RE: passlock repro.
Allright, saved me some bucks and a hassel.
Thanks
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
eknox327
2nd Generation S-series (1995-2005) Tech
25
12-13-2018 11:33 PM
knight1292
2nd Generation S-series (1995-2005) Tech
3
08-14-2008 09:30 AM