Power to fuse #15 "4WD" but no power to 4wd switch on dash.
#1
Power to fuse #15 "4WD" but no power to 4wd switch on dash.
Please disregard this post.
My wiring colors did not match the diagrams and I did my tests wrong.
I opened the switch, checked and cleaned the soldered connections, cleaned the board -especially the contact areas- and cleaned the harness connectors, and switch pins. Did the same on the transfer case control module and its connectors.
Plugged battery back in and now the switch lights up and the 4WD now works.
Reasons for the fix are unknown, as what I did is more akin to maintenance than repair, but I won't complain.
My wiring colors did not match the diagrams and I did my tests wrong.
I opened the switch, checked and cleaned the soldered connections, cleaned the board -especially the contact areas- and cleaned the harness connectors, and switch pins. Did the same on the transfer case control module and its connectors.
Plugged battery back in and now the switch lights up and the 4WD now works.
Reasons for the fix are unknown, as what I did is more akin to maintenance than repair, but I won't complain.
Last edited by Armorican; 06-09-2020 at 07:39 PM.
Thread
Thread Starter
Forum
Replies
Last Post
HOOPTY93
2nd Generation S-series (1995-2005) Tech
14
06-14-2015 04:04 PM
devestator_x
2nd Generation S-series (1995-2005) Tech
6
12-26-2007 10:08 AM