Hi there. I have a 89 Blazer that I want to run these two LED Neon Lights with. Currently I use the cigarette lighter but I hate the bulkingness of it. I would love to somehow wire these two up to a toggle switch but I'm sligjtly mechanically inclined. LOL Can someone please possibly explain to me how this can be done if at all? Any suggestions will be very much appreciated. Thanks.

- Sarah

 

so I guess there is no option to post pictures anymore? hmmm. well here is the link

http://www.the12volt.com/12voltimages/addremacc.gif

 

ok it is esay you are ging to have to fin out which wire is negive and positive the negitive is goung to have to be srewed to a meatel the floor the fire wall ect. then you are going to tacke and run the other wire to the place whare you are going to put switch you are going to have to spice a wire clip on the end of the wire and that clip should go on to the back of the togel switch on the switch ther are most of the time three prongs one is an acc. if you wont the light on the switch to work than you have to run a nother ground from that prong to a ground than thare are the other two pick one to run the led wire to the last prong youare going to run a wire from it whith the same kind of clip and it is going to go down to the junction bocks down by your brack pedil it should have an open prong just pick one they all have a constan power goning to them so if you do not remeber to turn off the lights you are going to get a dead battery this is the sempelest way to do it if you do not undestand some thing just let me know heer or at cemerson@sad5.org

 

hay if you give me your email i can sent you a better diagram to go by it could make it esayer