What are the holes from?

 

on the back bumper, they have holes to hole the strip in. Ill post pics later, still need to clean the tape up but it is looking more and more like an off road vehicle haha

 

Ohhhh OK. I knew they had that in the front, didn't realize it was in the rear too.

 

went offroading today first time, trails around where I live






It is 2wd but i still want to have some fun with it.. I think my blazer is equipped with open diff? I think later on if i really get serious with it, Ill get a locker or something. I figure people get stuck when they come to a dead stop, so i thought hey just dont stop. lol . Went up this hill close to my house, did not know there was some houses up there lol, obviously abandoned because only a truck can get up there . I didnt take pictures but getting up that hill was fun.

Got her nice and dirty =)


I need to remove that molding tape , Maybe do it at night time when Im borred and it is cool.

I am debating about removing the front sway bar.. i read on dezertdimes that alot of guys like how it feels when off roading, at the cost of a little more body roll on cornering.

 

Looks good (except for the adhesive tape ). I had the same problem with my rear bumper corners. Didn't want the three holes so I grabbed some new panels at a junkyard. Turns out the panels were from an older 95-97 truck with a slightly shorter bumper so they don't line up right on mine. still looks better than with the trim or holes

I think it would look great if you painted the chrome on the grille and bumper to match the rest of the truck