Did I Fubar this from the beginning?
Thread Starter
|
Junior Member
Joined: May 2010
Posts: 364
In this engine build I used a gasket in the oil housing and it covered this hole.
Upon removing this housing the gasket I installed was sucked into this area and deformed so as to allow the oil to move past the gasket.
The Main journal bearings look like this.
This block was not hot tanked.
Any help with this gasket question? Here is a picture of the gasket in place.
Upon removing this housing the gasket I installed was sucked into this area and deformed so as to allow the oil to move past the gasket.The Main journal bearings look like this.
This block was not hot tanked.
Any help with this gasket question? Here is a picture of the gasket in place.
Last edited by swartlkk; Apr 14, 2012 at 08:48 PM. Reason: *Combining Consecutive Posts* - Please use the edit function to add additional information in your post if another member has yet to respond and wait for a response. Rules are rules.
Thread
Thread Starter
Forum
Replies
Last Post
f10ski
Lighting & Electrical
1
Jan 13, 2013 05:13 PM
