4wd works then doesnt
#1
4wd works then doesnt
we had our first tiny little snow last night so I figured i'd go out and play. My 4wd would not engage at first lights would just blink. You can hear it trying to engage in the transfer case but it's not happening. At one point in time it actually did work in auto 4wd and stayed in for the rest of the drive. This morning it was back in 2wd and went on its own. Any ideas?
#2
Have you checked the connections at the dash switch, TCCM, and encoder motor for corrosion?
#3
I did get a small glimpse of the Vac Reservoir but it looks impossible to access it unless the ABS is removed off the vehicle or the front fender is taken off.
#4
You have a vacuum leak somewhere, going to have to track it down and fix it
#5
Update.
It was the front drive axle vacuum actuator solenoid GM Part # 15165891
They are like $55 at GM. Napa has them for just about $30
It was the front drive axle vacuum actuator solenoid GM Part # 15165891
They are like $55 at GM. Napa has them for just about $30
Last edited by AutomagicLS1; 12-14-2010 at 03:37 PM.
#6
About the issue you are having with the vents not blowing correctly. I found in my 92' Blazer that the clip on the flapper door down by the hump for the trans was disconnected from the rod. I had to bend it back and was a tight fit to get my hands in there but managed too and works fine now. Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
justblazin1
1st Generation S-series (1983-1994) Tech
1
10-19-2014 11:12 AM
aksallday
Steering, Suspension & Drivetrain
6
11-07-2013 05:08 PM
armydad71
2nd Generation S-series (1995-2005) Tech
8
05-23-2012 12:49 PM
dconnor.cfh
2nd Generation S-series (1995-2005) Tech
4
04-07-2012 10:48 AM
MEHusky
2nd Generation S-series (1995-2005) Tech
1
04-13-2008 01:48 PM