homeade skid plate design?
#21
12-26-2010, 01:47 PM
hmm I have been away for a minute but damn was this little project forgotten quickly...
click-tastic
seriously...
the only thing I would do differently is NOT cut in the filter door. unneccessary at best and 2 bolts do the same job.
click-tastic
seriously...
the only thing I would do differently is NOT cut in the filter door. unneccessary at best and 2 bolts do the same job.
#22
12-26-2010, 10:03 PM
hmm I have been away for a minute but damn was this little project forgotten quickly...
click-tastic
seriously...
the only thing I would do differently is NOT cut in the filter door. unneccessary at best and 2 bolts do the same job.
click-tastic
seriously...
the only thing I would do differently is NOT cut in the filter door. unneccessary at best and 2 bolts do the same job.
#23
12-26-2010, 11:33 PM
w00t! there is a write up somewhere around maybe page 5 or 8 in my build thread if you can dig it up... called project ripcord or somesuch 
i see yer rolling sans front bumper and valance... it's a good look... a lot more legal with bumper, but impressive none the less
i see yer rolling sans front bumper and valance... it's a good look... a lot more legal with bumper, but impressive none the less
Last edited by ABN31B; 12-26-2010 at 11:37 PM. Reason: MORE STUFFS!
Thread
Thread Starter
Forum
Replies
Last Post
Cerpindicular
2nd Generation S-series (1995-2005) Tech
4
07-14-2011 02:56 AM
