there were only two choices for bumper manufactuers that i could find...
This company is in the Pittsburg PA area called Logans Metal Products
Jamie is the gal i spoke to, very helpfull with lots of info..
They just started the production of the S-10 blazer line, they cater mostly to the jeep folks... and i got one of the first bumpers, maybe not the THE first but anyway, it is offered also with a pre-runner type bar on the front for a bit more in cost, took about a week and a half to get it, and came Fed-Ex.. yep this weekend i will put on some paint and go to the pick and pull yard to find a Blazer front grill and remove the chrome center bar and
fill in the area under the headlights, this bumper is designed for the Blazer not a Jimmy... it is different looking, now i need to locate a spot for some offroad lights

 

Man I can't wait to see this thing in person tomorrow!!

 

put a bwd cap and rotor on and rolled over 201000 today...!!!!

 

Good luck with that I had problems with the brand.

I got the money for my trucks inspection. Going to call tomorrow to see if i can drive her in

 

I cleaned it out, put the regular H4 housings back in, and put it up for sale. Here's hoping I'm moving up to something better, and not something worse.

 

Brought Her for inspection I need to go back at 1 pm ..... I crawled under to LUBE my fuel filter and my Freaking rear end seal is leaking..

I Fing tired JUST FING tired. RANT OVER

 

I repainted my front grille and the chevrolet logo. Before it was bedlinered but I found out the hard way that it will bubble from the heat of the engine so I sanded it down and spray painted it

 

Filled up the gas and check on the oil and other stuffs on my Blazer for a 2 1/2 hrs drive up north to Florence, Wisconsin. Going back up north tomorrow to start stripping the Blazer that I bought for parts all weekend I will be taking pictures of the parts with before/after. Will be back on here Sunday or Monday.

 

At least it is just the rear end seal is leaking. My blazer came with a busted tooth on the rear so i bought a rear off of a guy that claimed he rebuilt it, and he did... just not very well. He pinched the axle tube seal on the passenger side and it always leaks, just never got around to fixing it really. i just seem to luck out cause ive had not had a mechanic pull that wheel off yet and its been two years. But my luck will run out like always lol. Just hope thats all that is wrong xgiovannix12. Oh and i cleaned out my trash can of a blazer. must of had like 50 pounds of garbage lol

 

no its just the seal.

Edit: Blazers officially Inspected. Now to take care of her.... Going to be doing the fuel filter soon and replace the outlet line since I stripped it last night.

GO figure a Line wrench stripping an line fitting.... It was the correct size too. sigh