1st gen Tbar keys
#1
1st gen Tbar keys
OK, so instead of being able to put my puller on, I find this skidplate thing covering the Tbar adjusters. Im trying to change the keys out. I cant figure out how to get the damn bracket thing out of the way so I can put my tool on and proceed... Does anyone have any tricks or done this before? I gotta move that damn xmember out of the way.
Its a 1st gen.
All photos are the drivers side.
Heres looking at the suspect crossmember from front to back.
From the back looking at the Tbar crossmember, see how I can clamp on that edge nicely? The front side has some separate xmember that I cant figure out.
There is that notch that steps up that prevents me from even banging it to the front enough to attach my tool
See I have that thing in the way for the puller to attach.
Its a 1st gen.
All photos are the drivers side.
Heres looking at the suspect crossmember from front to back.
From the back looking at the Tbar crossmember, see how I can clamp on that edge nicely? The front side has some separate xmember that I cant figure out.
There is that notch that steps up that prevents me from even banging it to the front enough to attach my tool
See I have that thing in the way for the puller to attach.
Thread
Thread Starter
Forum
Replies
Last Post
NC93BLAZERLT
1st Generation S-series (1983-1994) Tech
4
11-23-2009 09:12 AM
old skool luvr
2nd Generation S-series (1995-2005) Tech
6
11-10-2009 09:20 PM